|
|
|
- Machining of top & lower liner landings and on-site re-sleeving of worn down area
- Removal of broken studs by drilling & machining
- Surface machining for flatness e.g. turret, foundation blocks, etc.
- On-site welding & machining of main/auxilliary stop valve for power generation plant
- On-site machining of rudder taper bore and tailshafts
- Vertical boring on bearing pockets, pintle housing and bearing, rudder bearing housing, etc.
- Line boring on engines’ main bearing pockets, turbine bearing pockets, etc.
- Milling works on pump foundation, rudder keyways, etc.
- Surface machining on pedestals, condenser covers, entablature landings, jackets and cylinder liners, etc. from 100mm to 3.5 meter in diameter
- Stern tube boring works
- Engine crankshaft (main and crank pin journals) machining, grinding and super-polishing works
- Machining and reaming of coupling fit bolt holes
- Honing works
- Laser alignment works.
|
|
|
|
|
